Ryobi Outdoor PLT3043E, RY70103 Silencer Guard Assembly, Silencer Guard Opening In Rear Housing

Models: PLT3043E, RY70103

1 18

Page 8

ASSEMBLY

See Figure 4.

1.Remove silencer guard and two screws from the owner’s kit.

2.Attach the silencer guard to the rear housing.

NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.

3.Using the torque wrench supplied, install the two screws and tighten securely.

TORQUE

WRENCH

SCREWS SILENCER

GUARD

BENT END OF

OPENING IN REAR

HOUSING

Fig. 4

Image 8

Contents

OPERATOR’S MANUAL Trimmer PLT3043E RY70103 SAVE THIS MANUAL FOR FUTURE REFERENCETABLE OF CONTENTS SAFETYGENERAL SAFETY RULES READ ALL INSTRUCTIONSSPECIFIC SAFETY RULES FOR TRIMMER USE SAFETYSYMBOLS SYMBOLNAME EXPLANATIONTECHNICAL DATA SYMBOLSSYMBOL MEANING SAVE THESE INSTRUCTIONSFEATURES ENGINE HOUSING THROTTLE INTERLOCK IGNITION SWITCH FRONT HANDLEUNPACKING INSTRUCTIONSASSEMBLY ASSEMBLY INSTRUCTIONSGRASS DEFLECTOR See FigureSILENCER GUARD ASSEMBLY REAR HOUSING TORQUE WRENCH SCREWS SILENCER GUARD BENT END OFSILENCER GUARD OPENING IN REAR HOUSING ASSEMBLYOPERATION FUEL AND REFUELLINGOPERATING THE TRIMMER HANDLING THE FUEL SAFELYADVANCING STRING USING THE EZ LINE TAP ADVANCE SYSTEM ADVANCING THE STRINGCUTTING TIPS GRASS DEFLECTOR LINE TRIMMING CUT-OFF BLADEIGNITION SWITCH STARTING AND STOPPINGSee Figures 8 and TO START A COLD ENGINEMAINTENANCE SPOOL REPLACEMENT EZ LINE TAP ADVANCE SYSTEMNEW PRE-WOUND SPOOL See Figures 10 andCLEANING THE EXHAUST PORT AND SILENCER STRING REPLACEMENTCleaning Instructions SPARK ARRESTERREPLACING AND CLEANING AIR FILTER FUEL CAPSPARKING PLUG STORAGE 1 MONTH OR LONGERTROUBLESHOOTING PROBLEMSOLUTION POSSIBLE CAUSEIDLE SPEED SCREW “L” LO NEEDLE TROUBLESHOOTINGPROBLEM SOLUTIONWARRANTY SAFETY DIRECTIVEGUARANTEE - STATEMENT RTSA / RTUK / RTG SOUND POWERRyobi Technologies GmbH Ryobi TechnologiesOPERATOR’S MANUAL Trimmer PLT3043E RY70103 Ryobi Technologies