Delay Brewing:
1.Fill the Water Reservoir with fresh cold water for the desired number of cups.
NOTE: Do not fill above the MAX line or less than the MIN line indicated on the Water Reservoir.
2.Press the Filter Basket Release Button and the Filter Basket Holder will swing outward. Fit a #4 coffee filter into the Filter Basket and fill with the desired amount of ground coffee.
NOTE: Use ground coffee specifically for automatic drip coffee makers. Usually one Coffee Measuring Scoop or a level tablespoon of ground coffee is used for each cup of coffee. Adjust the amount to your personal taste.
3.Close the Filter Basket Holder.
NOTE: If the door does not close completely, check to see that the Filter Basket and coffee filter are properly seated in the Filter Basket Holder then snap the door into place.
4.Place the Carafe with Lid on the Keep Warm Plate.
5.Plug into a 120 Volt AC outlet.
6.Ensure that the Clock is set with the current time.
7.Press the Program Button twice and the word TIMER will be shown in the display.
8.Press the HOUR and MINUTE (MIN) Buttons until the desired brew start time displays. Ensure that AM or PM display is correct. Press the Program (PROG) Button again (within 10 seconds) to save the set time.
9.At the set time the coffee maker will start the brewing cycle. Once the brewing cycle is complete the Coffee Maker will automatically switch over to ‘Keep Warm’ mode for a maximum of 2 hours. Press the On/Off Button twice or unplug the appliance to cancel the ‘Keep Warm’ mode. Both indicator lights will be out.
‘PAUSE & SERVE’ FEATURE
The ‘Pause & Serve’ feature allows you to pour a cup of coffee before the brew cycle has finished. Remove the Carafe slowly to temporarily stop the flow of coffee. Quickly pour a cup of coffee and reposition the Carafe securely on the Keep Warm Plate.
NOTE: Do not remove the Carafe for longer than 30 seconds.
5
