8
SOAKING/ELECTRIC CLEANING JEWELRY Check the Simple Guide (see page 11) to select the appropriate cleaning
method for your particular jewelry before proceeding.
NOTE: Make sure jewelry to be cleaned is at room temperature before
immersing in Cleaning Tank.
1.Place jewelry or multiple pieces of jewelry in the Jewelry
Cleaning Basket (12) as it sits in the resting position.
NOTE: Do not allow jewelry to extend through the
sides of the Jewelry Cleaning Basket and make contact
with the cleaning tank. Jewelry must make contact with
the gold plated portion of the Jewelry Cleaning Basket
for the cleaning process to be effective.
NOTE: If your jewelry is of a type which is not
recommended for electric cleaning, you may still soak the items
for 60 seconds in the warm cleaning solution bath before proceeding to steam
clean them.
2.Lift up the Jewelry Cleaning Basket from the resting position and submerge
it in to the cleaning bath. For proper alignment with electrical contacts,
ensure that the two tabs extending out from the Jewelry Cleaning Basket line
up with the two inserts extended off back wall of Cleaning Tank. Close the
lid to ensure a good connection with the contact points and lock the Jewelry
Cleaning Basket into place.
3.Press the Clean button to start the 60 second electric cleaning cycle. The
light will come on. When finished the cleaning action will automatically shut
itself off indicating the first step of the cleaning is done.
4.Slowly open Safety Cover (11) of Cleaning Tank all the way back and place
the Jewelry Cleaning Basket (12) into the resting position for removal of
jewelry. Let it drain completely. Proceed to Steam Cleaning Jewelry.
NOTE: After completing the steam cleaning process if there is still dirt and
grime stuck in grooves you can repeat the above steps as many times* as
needed for removal of dirt and grime.
*See Page 11 ���Simple Guide to Jewelry Cleaning” for exceptions.