Samson D1500, D1200 owner manual Stereo Sub Operation

Stereo Sub Operation

In larger rooms two or more Auro subwoofers can be used in stereo. For additional low-end, you can daisy chain a pair of Auro subwoofers to each side of your speaker system using the parallel THRU outputs.

To create a stereo full range audio system, two Auro Subwoofers can be used with any pair of powered full range enclosures. Follow these steps below for a system set-up using two D1200 or D1500 subwfooers with a mixer and a pair of powered satellite loudspeakers.

• Lower your mixer’s master outputs until they are turned off.

• Connect the mixer’s left output to the left side Auro subwoofer LINE INPUT A, and the mixer’s right output to the right side LINE INPUT B.

•If using the Auro D1200, connect the THRU A output to the line input of the left powered satellite, and the THRU B output to the line input of the right satellite. For the Auro D1500

connect HIGH PASS A output to the line input of the left powered satellite and the HIGH PASS B output to the line input of the right powered satellite.

• Set the level of your powered satellites up to normal operating level. Run an audio signal (such as music from a MP3 player) through your mixer, and raise the level to a comfortable listening volume.

•Slowly raise the Auro subwoofer LEVEL controls and adjust the two subwoofers to the desired level of low frequency output.

•When you raise and lower your mixer’s output, the two Auro subwoofers and satellites will track at the same relative volume.

Auro Active Subwoofer 9