Changing the
PowerBrite Nameplate
After you have received your new Custom Nameplate film, it’s a simple matter to install it. Begin by unplugging your PowerBrite and then unplug all devices connected to the rear and/or front panel outlets. Remove the PowerBrite from your rack and use both fingers to press gently on the two “Push” squares on the slide-out drawer so that it extends out towards you. With the drawer extended, turn the PowerBrite upside down. As described on page 10 in this manual, remove the clear plastic diamond lens at the bottom of the drawer. Then, as shown in the illustration below, use a Philips-head screwdriver to remove the two retaining screws holding down the metal nameplate bracket.
5. Bracket holder
4. White diffusor
3. Color film SAMSON 2. Logo film
1. Clear cover
Inside the window you will find a slot that holds a four-layer “sandwich” consisting of a clear cover (#1 in the illustration above, found closest to the window), logo film (#2), color film (#3), and white diffusor (#4).
Replace the logo film with your new custom Neo-Rack film (the color film can also optionally be replaced if desired) and then carefully put the layers back together in the same order, taking care to position the logo film correctly (it should be upside-down, since the PowerBrite itself is currently upside-down). Then just slide the “sandwich” back into the slot, replace the nameplate bracket and clear diamond lens and you’re done!
