The screen suddenly has become unbalanced.
strange after running a program or due to a crash between applications?
Has the video card been set properly?
Have you changed the video card or the driver?
Have you adjusted the resolution or frequency to the monitor?
Set the video card by referring to the video card manual.
Adjust screen image position and size using the OSD.
Adjust the resolution and frequency at the video card.
(Refer to the Preset Display Modes).
The screen is out of focus or OSD cannot be adjusted.
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.
Have you adjusted the resolution |
| Adjust the resolution and frequency of |
or frequency on the monitor? |
| the video card. |
|
| (Refer to the Preset Display Modes). |
LED is blinking but no images on the screen.
There are only 16 colors shown on the screen. The screen colors have changed
Is the frequency properly adjusted when checking the Display Timing on the menu?
Have the Windows colors been set properly?
Adjust the frequency properly by referring to the video card manual and the Preset Display Modes.
(The maximum frequency per resolution may differ from product to product.)
For Windows ME/2000/XP:
Set the colors properly at the Control Panel, Display, Settings.
after changing the video card.
There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found".
Has the video card been set properly?
Have you installed the monitor driver?
See the video card manual to see if the Plug & Play (VESA DDC) function can be supported.
Set the video card by referring to the video card manual.
Install the monitor driver according to the Driver Installation Instructions.
Install the monitor driver according to the Driver Installation Instructions.
Check the following items if there is trouble with the monitor.
1.Check if the power cord and the cable are properly connected to the computer.
2.Check if the computer beeps more than 3 times when booting.
(If it does, request an
3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.
4.Check if the scanning ratio of the video screen is set at 85Hz.
5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel, System, Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.
Note: If problems repeatedly occur, contact an authorized service center.
