4 6
1 3
.ABC DEF
C
OK
MENU
5
2
4 6
1
3
.ABC DEF
C
OK
MENU
5
2
Switching the Phone On and Off
19
Charging a Battery Pack18
You are supplied with a battery charger that must be
plugged into an appropriate wall socket (230V, 50Hz).
For more details about charging times, see page 16.
• The battery pack may become warm during charging. See
pages 12 and 13 for various safety precautions to be taken
with the battery pack.
• When the battery is discharged, and Low Battery
are displayed. Refer to the table in Step 3.
Amobile phone can only place and receive calls when
it is switched on.
1
1
2
2
4
3
1. Plug the travel adapter into the
bottom of the handset.
3. When is displayed (charging is
finished), unplug the adapter from the
phone by:
◆Pressing the two buttons on the
sides of the adapter plug
◆Pulling the plug
Refer to the table below when
checking the battery status.
2. Plug the travel adapter into an
appropriate wall socket.
Result:
• Charging begins
• The battery status indicator blinks
You can use the phone while
charging the battery pack.
However, the charge time will be
longer.
4. Unplug the adapter from the wall
socket.
Indication Battery Status
Discharged
1/3 full
2/3 full
Fully charged
2. When you have finished using the
phone, switch it off by pressing
again for two seconds.
Result:
• The phone gives a long beep
• Power Offappears
• The display is cleared
• The battery is no longer being used
To enable the phone to lock
automatically when switched off.
See page 49.
/
I
Power Off
1. Switch the phone on by pressing
for at least two seconds.
Result:
• The phone gives a long beep
• The greeting message is displayed
• The phone scans for the available
network; when the network name
is displayed, you can place and
receive calls
• If Phone Lockis displayed,
enter the password first (see
page 49).
• When you switch the tele-
phone on for the first time,
Enter PIN:is displayed
(see page 20).
• If Check Cardis displayed,
check that your SIM card is
correctly installed (see page
15).
/
I
01-250 4/2/99 11:48 AM Page 18