Dot Acceptable
black pixels may be seen. This is not from bad quality and you can use it without
any problems.
For example, the number of TFT-LCD sub pixels contained in this product are
6,220,800.
Note
Design and specifications are subject to change without prior notice.
Note
• UX-2 - Class B Equipment (Information Communication equipment for residential use).
• UXN-2 - Class A Equipment.
PowerSaver
This LCD Display has a built-in power management system called PowerSaver. This system
saves energy by switching your LCD Display to low-power mode when it has not been used
for a certain amount of time. The LCD Display automatically returns to normal operation when
you press a key on the keyboard. For energy conservation, turn your LCD Display OFF when
it is not needed, or when leaving it unattended for long periods. The PowerSaver system
operates with a VESA DPM compliant video card installed in your computer. Use the software
utility installed on your computer to set up this feature.
PowerSaver (When used as a Network monitor)
State Normal Opera-
tion Power saving
mode Power off
(Power-switch)
Power Indicator On Blinking Off
Power Con-
sumption 400UXN-2 190 watts Less than 5 watts Less than 5 watts
460UXN-2 250 W Less than 5 watts Less than 5 watts
PowerSaver (When used as a normal monitor)
State Normal Opera-
tion Power saving
mode Power off
(Power-Button)
Power Indicator On Blinking Off
Power Con-
sumption 400UX-2 160 W Less than 2 watts Less than 1 watts
460UX-2 210 W Less than 2 watts Less than 1 watts
Preset Timing Modes
If the signal transferred from the computer is the same as the following Preset Timing Modes,
the screen will be adjusted automatically. However, if the signal differs, the screen may go
blank while the power LED is on. Refer to the video card manual and adjusts the screen as
follows.
Display Mode Horizontal
Frequency
(kHz)
Vertical Fre-
quency (Hz) Pixel Clock
(MHz) Sync Polarity
(H/V)
IBM, 640 x 350 31.469 70.086 25.175 +/-
Specifications