- Check the displays to see if any of the other displays connected have the same ID. If more than one displays have
the same ID, those displays are not properly det ected by the program due to data conflict.
- Check if the Display Set ID is a number between 0 and 16 . (Adjust using the Display menu)
Note : A Display Set ID must be a value between 0 and 16 .
2. The display you wish to control does not appear on the other Control Info Grids
- Check to see if the display power is ON. (You can check this in Power Control Info Grid)
- Check if you can change the input source of the display.
3. The dialogue box appears repeatedly.
- Check to see if the display you wish to control is select ed.
4. Both On Timer and Off Timer have been set but different time is showing.
- Apply current tim e to synchronize the display clocks.
5. The remote may not function properly when you turn off the remote Function, disconnect the RS-232C cable, or exit
the program in an Irregular manner. Reru n the program and turn the remote function aga in to Restore normal
functions .
<Note> This program may malfunction due to proble ms in communication circuits or interference from electronic
appliances nearby.
Settings Value Display I n Multiple Display Mode
When there are more than one d isplays connected, the setti ngs values are displayed as follow s.
1. No selection: Displays the Factory Default Value.
2. Selected one display: Fetches and displa ys the settings value for the sele cted display.
3. Selected one display (ID1) and add another display (ID3): The prog ram, which was displaying the settings value of
ID 1, fetches and displays the value of ID3.
4. Selected all sets using Select All: Returns to the Factory Default Value.