Samsung 940FN If problems repeatedly occur, contact an authorized service center, Q & A, Question

		Control Panel -> Performance and
		Maintenance -> System ->
		Hardware -> Device Manager ->
		Monitors -> After deleting Plug and
		Play monitor, find 'Plug and Play
		monitor' by searching new
		Hardware.
		MagicTune™ is an additional
		software for the monitor. Some
		graphic cards may not support your
		monitor. When you have a problem
		with the graphic card, visit our
		website to check the compatible
		graphic card list provided.
		http://www.samsung.com/monitor/magictune
MagicTune™ doesn't	Have you changed your	Download the latest program. The
work properly.	PC or video graphic card?	program can be downloaded
		http://www.samsung.com/monitor/magictune.

Visit the MagicTune™ website and download the installation software for MagicTune™ MAC.

Check the following items if there is trouble with the monitor.

1.Check if the power cord and the video cables are properly connected to the computer.

2.Check if the computer beeps more than 3 times when booting.

(If it does, request an a service for the main board of the computer.)

3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.

4.Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz. (Do not exceed 75 Hz when using the maximum resolution.)

5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel¡ System¡ Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.

If problems repeatedly occur, contact an authorized service center.

Q & A

Question

How can I change the frequency?

Answer

The frequency can be changed by reconfiguring the video card.

Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)

How can I adjust the resolution?

How can I set the Power Saving function?

How can I clean the outer case/LCD Panel?

Windows ME/XP/2000 : Set the resolution at the Control Panel¡ Display¡ Settings.

* Contact the video card manufacturer for details.

Windows ME/XP/2000 : Set the function at BIOS-SETUP of the computer or the screen saver. (Refer to Windows/Computer Manual).

Disconnect the power cord and then clean the monitor with a soft cloth, using either a cleaning solution or plain water.

Do not leave any detergent or scratches on the case. Do not let any water enter the monitor.