Connecting the FM and AM(MW/LW) Antennas
AUX Connections
1 2 3
If FM reception is poor, connect outdoor FM antenna (not supplied).
AM Loop Antenna (supplied)
ANTENNA
Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.
TV
To view pictures from external input (AUX 1, AUX 2), first connect the VIDEO IN jack
VIDEO IN (VIDEO 1 or VIDEO 2) and then connect the VIDEO OUT jack.
FM Antenna (supplied)
WOOFER | CENTER | ||
|
|
| IMPEDANCE |
Cooling fan (See “About Cooling Fan” below.)
IMPEDANCE
Audio Cable (Red/White)
If the external analog component has only one output jack, you may connect either L or R.
FM antenna connection
1.Connect the FM antenna supplied to the FM 75 COAXIAL terminal as temporary measure.
2.Moderately strain the antenna wire and then fasten it to a wall or other rigid surface within a location where reception is good.
•If reception is poor, connect an outdoor antenna. Before attaching a 75 coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
(About the cooling fan)
A cooling fan is mounted on the rear panel of the center unit to prevent abnormal temperature inside the center unit, thus assuring normal operation of the unit. The cooling fan automatically starts rotating to supply external cool air to the inside of the center unit when the internal temperature exceeds the specified limit.
AM(MW) antenna connection
1.Connect the AM loop antenna supplied
to the AM and terminals.
2.If reception is poor, connect an outdoor single
For safety, observe the following carefully.
•Make sure there is good ventilation around the center unit. Poor ventilation could overheat and damage the canter unit.
•DO NOT block the cooling fan and the ventilation openings or holes. (If they are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)
External Analog
Components
• Always connect the video and audio connection cables to the
R L
equivalent colored jack.
Connect to external equipment with analog output.
Example: Video, TV, LDP, etc.
•Even if DIGITAL IN is selected, if the video input jack of an external analog component is connected to the player’s VIDEO IN connector, the player will still output a video signal from the analog component.
|
| Making Analog Input Selection |
|
Remote Control | Press the AUX button and select AUX1 IN, AUX2 IN. | ||
Main Unit | Press the Function button and select AUX1 IN, AUX2 IN. | ||
|
|
|
|
11 | 12 |