Cooling Your Room
You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan speed.
1Press the 
(On/Off) button.
Result: ◆ The air conditioner starts up in the mode selected when the unit was last used.
◆The unit beeps twice.
☛The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
It will start up normally after three minutes.
2If the temperature is not displayed on the control panel:
◆Press the 
button on the unit one or more times until the temperature is displayed.
Result: ◆ The unit beeps each time you press the 
button.
◆The air conditioner starts up in the Cool mode.
➢You can change modes at any time.
3To adjust the temperature, press the 
or 
buttons on the unit one or more times until the desired temperature is displayed.
The temperature can be set between 18°C and 30°C.
Result: ◆ Each time you press the 
or 
buttons:
–The temperature is adjusted by 1°C and displayed on the control panel
–The unit beeps
◆The air conditioner starts cooling, if the room temperature is higher than the selected temperature.
◆If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating.
4To set the fan speed:
◆Press the 
button on the unit one or more times until the desired the Fan speed(F1, F2 or F3) is displayed.
Low
Medium
High
5To control the direction of the air flow, refer to page 20.
