Samsung DMS790BUB/XEE manual Indicator lights, Relating to programming, display

The indicator lights

Problem		Possible Causes	What to do?
	• No salt or an insufficient quantity		• Refill the tank and wait for the
The salt light does not		of salt in the tank to trigger the	cycle to end. If you have soft
go out		float.	water that requires no salt, the
			light is constantly lit.
The lights all light up	•	Wrong programme.	• Cancel the current programming
			by holding down the Start button
one after the other A
			for 3 seconds and then re-
light flashes and the
			programme.
programme does not
	•	Programme selector wrongly	• Reposition the selector on a
start
		positioned (between two notches).	programme.

Relating to programming, display

Problem		Possible Causes		What to do?
	•	The energy-saving programmes	•	Use these programmes
		last longer because the agitation		preferably at night when it is
The cycle lasts too long		and drying times are longer to		not so important how long the
		compensate for the lower washing		programme lasts or when it ends.
		and drying temperatures.
	• Insufficient amperage to supply		• Check the socket’s amperage
The appliance trips the		all the appliances being operated		(10A minimum) and the meter’s
		simultaneously.		capacity.
circuit breaker
	• Internal fault in the appliance.		•	Call a technician.
	• No mains power to the socket.		• Check the socket and the fuse.
	• Tap closed (Cf. table fault d01).		• Check the tap is open.
	• Water supply hose kinked.		• Check the hose line is OK.
The appliance does not
	• Selection error or programme		• Cancel by holding down Start for
start
		blocked.		3 secs and re-programme.
	• Start button pressed too long		• Just press Start briefly to start the
		(greater than 2 secs).		programme.
	• Appliance in Safety mode		•	Call a technician.
		(antileak) (Cf. table fault d07).
The appliance will not	• Door opened during a washing		• Wait for the time delay to end
		cycle.		(controlled internally by the
restart
				appliance).

24_ troubleshooting