OPERATING THE RECEIVER
4.5 System Information
If you have to contact your service provider or a service center they might ask for information available from this menu.
Place the cursor on this sub menu and press the OK key. The following will be the
Note : If you forgot PIN Code, press ‘0’ key four times. Then, current PIN Code is displayed.
Keep in mind that your children or other people can get this PIN Code using this method.
4.6 Software Upgrade
You can download and upgrade the software of this STB through ASTRA and Hotbird or Sirius satellite when the new software is released.
Note : These satellites for upgrading software on Samsung
Brand can be changed in the future.
During downloading don’t turn off the STB.
If there is a new version of software to download, you are asked if you will update or not.
If you press OK key, the update starts right away.
In case update is impossible, you get this message “You can’t update software!”
Or in case you don’t need to update, “You don’t need to update software!” will be displayed. If you get information that a Transponder is changed to different one for Samsung software, you should select ‘User Advanced Mode’ at Menu mode by using the / key.
Then you should set exact parameters for the new transponder for Samsung.
Note : Upgrade via Personal Computer
To maintain the STB
New versions of the software may include new or improved functions for the latest one. If you want to download and upgrade the software via personal computer, visit our homepage (http : //www.samsungstb.com) to get more information and the new software. You can check to see the correct version was installed by comparing the software version in the 4.5 System Information menu.
OPERATING THE RECEIVER
4.7 Copy Channel Data
If you want to copy the channel data from one receiver to another, please follow the instruction below.
Please make your own channel data, such as favorite & lock channel with your own master box.
Then take your master box when you install another box.
1.Plug on both master & slave receivers
2.Master Box(Installed Box) :
3.Slave Box(Installing Box) : Menu Mode
4.Connect 2 Boxes with RS232 serial cable
(Both end should have male connector with crossed signals)
5.Select the ‘System Setup’ and press the OK key.
6.Select the ‘Copy Channel Data’ with the / keys.
7.Press ‘OK’ to start channel data copy
GB
D I G I T A L | S A T E L L I T E | R E C E I V E R |
