TROUBLESHOOTING
TECHNICAL SPECIFICATIONS
Problem | Possible cause | Solution of the problem |
|
|
|
No display LED on | Power cord | Power cord plug in correctly |
the front panel; | not plugged in correctly |
|
No power supply |
|
|
|
|
|
No pictures on the screen | Receiver in Standby mode; | Set receiver to “On”; |
| Scart not connected tightly | Check connection and correct; |
| to video output of television; |
|
| incorrect channel or video | Check channel and video output and |
| output selected on television | correct (TV instruction manual) |
|
|
|
No sound | Audio cord connected | Check connection and correct; |
| incorrectly; |
|
| Loudness level = 0; | Increase loudness on television set; |
| Muting active | Press the MUTE key |
|
|
|
Remote Control does not | incorrect operation; | Point remote control |
operate directly |
| towards the Receiver. |
| Batteries dead or inserted | Replace batteries or insert correctly |
| incorrectly |
|
|
|
|
Poor picture quality | Signal strength to low | Check all wire connections. Check the |
signal strength in |
| the “Auto Scanning” menu, correct |
|
| alignment of your antenna |
|
|
|
Antenna cable not connected | Check connection and correct; | |
“Searching for signal” | or not tight; |
|
| LNB defective; | Change LNB; |
| incorrect position of the | Check position and correct, |
| satellite antenna; | Check the signal strength in |
| LNB is set to "OFF" in | the “Auto Scanning” menu |
| LNB Setting menu |
|
|
|
|
Satellite not yet set | Scan of in “Automatic scanning” | |
“Channel data |
| or “Manual scanning” menu |
does not exist.” |
|
|
|
|
|
Smartcard: | (depend on model) | |
“Please check the | - not plugged in correctly; | Check the Smartcard. |
Smartcard”; | - not plugged in. | “Insert the Smartcard.” |
“Please insert the |
|
|
Smartcard”. |
|
|
|
|
|
Power supply
Type :
Input voltage :
Fuse rating :
Tuner
Freq. Range : Input signal level : Channel selection : Input impedance : Connector type : LNB power control : DiSEqC :
Demodulator
Type :
Symbol rate :
Inner FEC :
Outer FEC :
Video decoder
System decoding :
Profile and level : Data rate : Video formats : Picture resolution :
Audio Decoder
System decoding : Audio mode : Sampling frequency :
SMPS
AC
950 ~ 2150 MHz
PLL frequency synthesizer 75 Ω unbalanced
F type female
13 V/18 V, 22 kHz tone
1.2 supported
QPSK DEMODULATION (DVB-S)
2 ~ 45 Ms/s
Viterbi Convolutional
Coding Rate - 1/2,2/3,3/4,5/6,7/8 Reed Solomon Coding (204,188), t = 8
MPEG 2 ISO/TEC 13818 (Transport Stream) MPEG 2 MP@ML (4:2:2) 1~ 15 Mb/s
4:3 (normal) & 16:9 (widescreen) 720(H) x 576(V) x 50 fields/sec
MPEG 1 ISO/TEC 11172~3 layer I & II MONO, DUAL, STEREO, JOINT STEREO 32, 44.1, 48 kHz
GB
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with household refuse. Please obtain appropriate information about the regulations in your community, and dispose of all refuse in accordance with regulations at the separate locations provided.
D I G I T A L | S A T E L L I T E | R E C E I V E R |
