SETUP
1. DIGITALAUDIO OUT JACKS
• Use either an optical or coaxial digital cable to connect to a compatible Dolby Digital receiver.
Use to connect to an A/V Amplifier that contains a Dolby Digital or DTS decoder.
2. ANALOG AUDIO OUT JACKS
• Connect to the Audio input jacks of your television, audio/video receiver.
3. VIDEO OUT JACKS
• Use a video cable to connect to the Video input jack on your television.
4. S-VIDEO OUT JACK
• Use the S-Video cable to connect this jack to the S-Video jack on your television for a higher
quality picture. The S-Video must be selected in the VIDEO OUTSELECT.
5. COMPONENT VIDEO OUT JACKS
• Use these jacks if you have a TV with Component Video in jacks. These jacks provide Pr, Pb and
Yvideo. Along with S-Video, Component Video provides the best picture quality.
The COMPONENTmust be selected in the VIDEO OUT SELECT.
6. VIDEO OUT SELECT SWITCH
• Use the switch to set video out. If COMPONENTis selected, S-Video may not work. If S-Video is
selected, COMPONENTmay not work.
* Select the VIDEO OUTSELECT switch in the Stop or Power Off mode.
NOTE
Description-Rear Panel Description-Rear PanelRear Panel
12 13
DVD-E138A/DVD-1010/DVD-E138B/DVD-E238
DVD-E338K
123
45
6
12
3456
E138A 00141K-1(GB)XTC 4/9/03 10:21 AM Page 12