Samsung DVD-R100 Connecting & Setting Up

English -

15

Step 1: Unpacking

Method 1 : Antenna + DVD

Recorder + TV : No Cable box

You can record non-scrambled channels by selecting the

channel on the DVD Recorder. Also use this Method if

you watch channels without cable box.

Method 2 : Antenna +Cable box +

DVD Recorder + TV : Cable box

with many scrambled channels

You can record channels by selecting the channel on the

cable box. You cannot record one channel while watch-

ing another channel. Be sure that the cable box is turned

on.

Accessory

Check for the supplied accessories below.

●

Video/Audio Cable (AC39-42001R)

●

RF Cable for TV (AC39-42001J)

●

Remote Control (AK59-00023A)

●

Batteries for Remote Control (AAA Size)

(4301-001035)

●

Instruction Manual (AK68-00427A)

●

Quick Guide (AK68-00493A)

There are several ways to connect your DVD Recorder.

Select one of the following antenna connections that

best suits you below.

●

Method 1 : Antenna + DVD Recorder + TV : No Cable

box

●

Method 2 : Antenna +Cable box + DVD Recorder +

TV : Cable box with many scrambled channels

●

Method 3 : Antenna + DVD Recorder + Cable box

+TV : Cable box with a few scrambled channels

Step 2: Connecting the Antenna

Cable

■

If you are using an off-air antenna that has

300-ohm twin flat leads, use an external

antenna connector (300-75 ohm adaptor :

not supplied) to connect the antenna to

the DVD Recorder.

■

If you have two separate antennas (one

VHF and the other UHF), use a UHF/VHF

combiner-adaptor (available at most elec-

tronics shops) to connect the antenna to

the DVD Recorder.

■

The VHF/UHF RF OUT jack of this prod-

uct sends only signals received through

the antenna. It does not output Audio/

video signals. You must connect

audio/video cables to view Video from the

unit. (i.e. DVD playback)

NOTE

14

- English

A Quick Overview presented in this guide will give you

enough imformation to start using the recorder.

Connecting &

Setting Up

Quick Overview

Quick Overview .....................................................14

Step 1 : Unpacking.................................................15

Step 2 : Connecting the Antenna cable

..............

15 Step 3 : Connecting the Video cable.....................16

Step 4 : Connecting the Audio cable ....................18

Step 5 : Connecting the external devices .............20

Step 6 : Connecting the Power cord.....................21

Step 7 : Preparing the Remote Control.................21

Step 8 : Initial Setup...............................................23

This section involves various methods of connect-

ing the DVD player to other external components

and required initial setting modes.

Step 1 : Unpacking

Step 2 : Connecting the Antenna Cable

Step 3 : Connecting the Video Cable

Step 4 : Connecting the Audio Cable

Step 5 : Connecting the external devices

Step 6 : Connecting the Power Cord

Step 7 : Preparing the Remote Control

Step 8 : Initial Setup

†

●

Note to CATV system installer: This reminder is pro-

vided to call CATV system installer’s attention to

Article 820-40 of the National Electrical Code

(Section 54 of Canadian Electrical Code, Part I), that

provides guidelines for proper grounding and, in par-

ticular, specifies that the cable ground shall be con-

nected to the grounding system of the building as

close to the point of cable entry as practical.

Connecting & Setting UP