Samsung GE86N-B/XEH manual Cooking / Reheating Power Levels, Stopping the Cooking

Cooking / Reheating Power Levels

The following procedure explains how to cook or reheat food.

ALWAYS check your cooking settings before leaving the oven unattended.

First, place the food in the centre of the turntable. Then, close the door

1.Press the button.

Result :	The 850 W (maximum cooking power)
	indications are displayed:
	Select the appropriate power level by pressing
	the	button again until the corresponding

wattage is displayed. Refer to the power level table.

2. Set the cooking time by Pressing the ( ) and ( ) buttons as required.

3.Press the button.

Result : The oven light comes on and the turntable starts rotating.

1) The oven beeps four times.

2)The end reminder signal will beep 3 times (once every minute).

3)The current time is displayed again.

Never switch the microwave oven on when it is empty.

If you wish to heat a dish for a short period of time at maximum power(850 W), simply press the +30s button once for each 30 seconds of cooking time. The oven starts immediately.

You can choose among the power levels below.					EN
Power Level			Output
		MWO		GRILL
HIGH		850 W
MEDIUM HIGH		600 W
MEDIUM		450 W
MEDIUM LOW		300 W
DEFROST(	)	180 W
LOW / KEEP WARM		100 W		1100 W
GRILL		-
COMBI I(	)	600 W		1100 W
COMBI II(	)	450 W		1100 W
COMBI III(	)	300 W		1100 W

If you select higher power level, the cooking time must be decreased.

If you select lower power level, the cooking time must be increased.

Stopping the Cooking

You can stop cooking at any time to check the food.

1.To stop temporarily;

Open the door.

Result : Cooking stops. To resume cooking, close the door and press again.

2.To stop completely;

Press the button

Result : The cooking stops. If you wish to cancel the

cooking settings, press the Stop () button again.

You can also cancel any setting before starting by simply pressing Stop ().

Adjusting the Cooking Time

You can increase the cooking time by pressing the +30s button once for each 30 seconds to be added.

Press the +30s button once for each 30 seconds to be added.

7