Quick Start Guide
Bluetooth
Mono Headset
WEP200
Get connected in 4 quick steps
Charge your headset
Put your headset in pairing mode Turn on Bluetooth on your phone and pair with headset
Test and use
Start here 
Before using your headset
Thank you for purchasing the Samsung Bluetooth Mono Headset WEP200, we hope you will be delighted with its operation.
Take a moment before you get started to familiarize yourself with your new headset.
| |
Hook | Indicator light |
| |
Volume control | Microphone |
buttons |
|
| Charging contact |
Check the accessories
Make sure you have the following items with your headset:
Set 1:
Charging case, Travel adapter, Manual, 2 headset hooks
Set 2:
Charging case, Manual, 2 headset hooks For Set 2, use your phone charger as a power source for recharging.
NOTE:
Your headset supports the headset and/or
Charge your headset
Charge the headset's battery fully before using the headset for the first time.
1Put the headset in the supplied charging case and close the cover.
2Plug the travel adapter into the case's charging socket.
3Plug the travel adapter into the electrical outlet.
•For Set 1, use the travel adapter provided.
•Charge the headset until the red light on the headset turns to blue.
•The headset will be fully charged in approximately 2 hours.
4Remove the travel adapter from the case.
NOTE:
The headset cannot be used while charging.
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/ accessories
Customer Care Center:
Guide No.:
09/2006. Rev. 1.2
Put your headset in pairing mode
Before you can use your headset, you must pair it with your phone.
1Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2Press and hold the
The indicator light flashes in blue as you press and hold the
Turn on Bluetooth on your phone and pair with headset
1Set your Bluetooth phone to discover the headset by following your phone's guide.
Typically, the steps involve going to the Settings, Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices.
Your phone will find the Samsung WEP200 headset.
2Select Samsung WEP200.
3When the phone asks if you want to pair with it, confirm by selecting Yes or OK.
4Enter the headset passkey or PIN, 0000.
Test and use
Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call:
1Place the headset over your ear.
See Wearing the headset on the reverse side of this guide.
2On your phone, make a call to the number you want.
3If your phone and headset are successfully paired, you will hear ringing on the headset.
After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset.
Using your WEP200
See Features and Functions Guide on the reverse side of this guide
for information on using your WEP200.
