INSTALLATION
Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable

TV system (according to the instructions on pages 10-13). Skip step 1if you have not yet

connected to an antenna or a cable system.

14

1
Connect a coaxial cable between the “ANT IN”
terminal on the TV and the ANTENNAOUT terminal on
the VCR.
A coaxial cable is usually included with a VCR. (If
not, check your local electronics store).
2
Connect a set of audio cables between the “AV IN 1
(L, R)”(or “AV IN 2 (L, R)”) jacks on the TV and AUDIO
OUTjacks on the VCR.
If you have a mono VCR, connect L(mono) to VCR
audio out using only one audio cable.
3
Connect a video cable between the “AV IN 1 (VIDEO)”
(or “AV IN 2 (VIDEO)”) jack on the TV and the VIDEO
OUT jack on the VCR.
Follow the instructions in “Viewing a VCRor
Camcorder Tape” to view your VCR tape.

Connecting a Second VCR to Record from the TV

Your TV can send out signals of its picture and sound to be recorded by a second VCR. To do

this, connect your second VCR as follows:

1
Connect a set of audio cables between the “AV OUT
(L, R)” jacks on the TV and the AUDIO IN jacks on the
VCR.
(The VCR input jacks might be either on the front or
rear of the VCR.)
2
Connect a video cable between the “AV OUT (VIDEO)”
jack on the TVand the VIDEO IN jack on the VCR.
Refer to yourVCR’s instructions for more information
about how to record using this kind of connection.

•Also, you can connect to “AV 3” on the side panel of TV.

BP68-00284A-02Eng 7/20/04 3:26 PM Page 14