yy RJP (Remote Jack Pack): RJP stands for Remote Jack Pack. The RJP is a hardware module that has different Audio Video inputs (A/V, Audio, PC and HDMI) and corresponding outputs. The corresponding outputs are connected from the RJP to the TV. The RJP communicates with the TV via RS232. A Hot Plug & Play function allows hotel guests to connect an external source to the RJP. The RJP communicates with the TV by sending messages regarding Active/Inactive sources.
A group of menu items, RJP Priority AV, RJP Priority PC, and RJP Priority HDMI, let you assign numbered priorities to the jacks of the RJP. 1 is the highest priority and 3 is the lowest. When a guest connects external sources to the RJP jacks, the TV will automatically switch between sources based on the priority you have assigned them in the Menu. For example, lets say AV is set to 1 and HDMI to 2. If a guest has attached a device to the HDMI jack, and then plugs a device into the AV jack, the TV automatically switches to the device plugged into the AV jack (the jack with the higher priority). Note that a guest can also switch between devices manually by pushing a button on the RJP.
✎✎ You connect the RJP to HDMI 1, 2, or 3 or AV 1 or 2.
✎✎ When the TV is on, connect the TV and the RJP within 10 seconds.
yy The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10 seconds. All LEDs blink 5 times, acknowledging that the reset has been performed
yy The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.
yy After an RJP Reset or a TV Power OFF/ON, it takes approximately 10 seconds to establish communications between the TV and the RJP.
yy The following table shows the approximate time in seconds it takes to switch from the TV to an input source, based on assigned or default priorities.
✎✎ Scenario 1: When no inputs are connected.
Source | To Connect |
|
|
AV | 2 Sec |
PC | 0.7 Sec |
HDMI | 3.9 Sec |
✎✎ Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.
Source | Disconnect | To Connect | Total |
|
|
|
|
AV | 4.5 Sec | 2 Sec | 6.5 Sec |
PC | 0.7 Sec | 0.7 Sec | 1.4 Sec |
HDMI | 3.9 Sec | 3.9 Sec | 7.8 Sec |
✎✎ An example: If the RJP has all its live sources (AV, PC, and HDMI) connected, AV has been assigned the highest priority, the RJP is in HDMI mode, and a guest removes and reconnects the AV source, the minimum time required to switch to the AV source is 6.5 seconds.
yy To connect audio (Ipod or Mp3), Music mode should be ON. yy A/V, PC, and HDMI input sources are supported.
16 English
[HG470570
8:41:03
