Installing the Speakers on the Half Tallboy Stand
02
*
1.Stretch out the speaker cable and arrange it through the hole of the stand base as shown.
2.Tighten the stand nut (C) as shown and use the stand screwdriver (D) to tighten it in the arrow direction.
3.This is after the speaker is installed completely. Tighten the other speakers in the same manner.
1 
2
3
Conne
Installing the Speakers on the Tallboy Sta
*
1.Turn the Stand Base
2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Connect the upper Speaker to the assembled Stand.
4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
1
Stand
Base
Stand
3
Speaker
Stand
5
2 |
4 |
Adjusting the height of the Half Tallboy Speaker
*
1. If you want to change the speaker position (height), | 1 | |
remove two screws in the rear side. | ||
|
2. Pull up the speaker in the arrow direction as shown. (See fi gure 2)
! CAUTION : Do not apply excessive force. Otherwise, it may cause a physical injury.
2 |
English 1 |
