
Connections
Adjusting the height of the Half Tallboy Speaker
*HT-D453HK only - Front Speakers
1.If you want to adjust the height of the speaker, loosen 3 screws on the rear of the speaker base fi rst.
2.Pull up the speaker in the arrow direction. (See fi gure 2)
!CAUTION : Be careful as an excessive force may result in a physical damage.
3.Fit the speaker in a height adjusting hole of your choice. For the height information, check the following examples. (570mm for the default height)
Ex) Hole 1: 650mm in the speaker height Hole 2: 635mm in the speaker height
4.Close the cover as shown and tighten back the 3 screws.
5.This is after the height of the speaker is adjusted. You can repeat these steps above at any time if you want to readjust the height.
1 |
3 |
5
2 |
4 |
Connecting The Speakers
1. | Press down the terminal tab on the back of the speaker. |
|
2. | Insert the black wire into the black terminal |
|
| terminal (+), and then release the tab. |
|
3. | Connect the connecting plugs to the back of the product by matching the | Black |
| Colors of the speaker plugs to the speaker jacks. | |
|
|
In case of HT-D450K
Red
Front Speaker (R)
Surround Speaker (R)
Center Speaker
Front Speaker (L)
Surround Speaker (L)
Subwoofer
* Refer to page 16 for the speakers of