Samsung HT-D455/EN Adjusting the height of the Half Tallboy Speaker, Connecting The Speakers

Connections

Adjusting the height of the Half Tallboy Speaker

*HT-D453H only - Front Speakers

1.If you want to adjust the height of the speaker, loosen 3 screws on the rear of the speaker base first.

2.Pull up the speaker in the arrow direction. (See figure 2)

!CAUTION : Be careful as an excessive force may result in a physical damage.

3.Fit the speaker in a height adjusting hole of your choice. For the height information, check the following examples. (570mm for the default height)

Ex) Hole 1: 650mm in the speaker height Hole 2: 635mm in the speaker height

4.Close the cover as shown and tighten back the 3 screws.

5.This is after the height of the speaker is adjusted. You can repeat these steps above at any time if you want to readjust the height.

1

3

Hole 1

Hole 2

5

2

4

Connecting The Speakers

1.Press down the terminal tab on the back of the speaker.

2. Insert the black wire into the black terminal (–) and the red wire into the red terminal (+), and then release the tab.

3.Connect the connecting plugs to the back of the product by matching the

colours of the speaker plugs to the speaker jacks. Black

In case of HT-D453H

Center Speaker

Front Speaker (R) Front Speaker (L)

Red

Surround Speaker (R)

Surround Speaker (L)

Subwoofer

* Refer to page 16 for the speakers of HT-D455.

18 English

HT-D450-XY-ENG-1228.indd 18 2011-12-28 ￿￿ 5:48:16