Samsung HT-DS1000 Unit as follows, Press ASC button, When the message Remove MIC

Plug the auto sound calibration

1 microphone into the auto sound calibration input jack.

	Place the auto sound calibration
2 microphone at the listener's position.
3		Adjust the volume control on the main
	•	unit as follows:
		If the distance between the listener and the speaker is over 16.5 feet:
	•	Set the main unit's volume to over 25.
		If the distance between the listener and the speaker is 10 to 16.5 feet:
		Set the main unit's volume to 25.
	• If the distance between the listener and the speaker is below 10 feet:
		Set the main unit's volume to 15.
4	Press ASC button.
	• The tone will be output twice, in the given order (L ➝ C ➝ R ➝ RS ➝
		LS ➝ SW), and 5.1-channel sound field is optimized automatically.

• The auto sound calibration setup takes about 2 minutes to complete.

A bell sounds and the setup finishes.

A tone is output. A result for each speaker is displayed.

When the message "REMOVE MIC"

5 appears in the display, unplug the auto sound calibration microphone.

To cancel the auto sound calibration setup, press ASC button.

•The tone output stops, "CANCEL ASC" appears in the display followed by "REMOVE MIC", and the setup is cancelled.

To listen in the auto sound calibration mode, briefly press ASC button.

•The selection alternates between ASC ON and ASC OFF in the display.

•If you select "ASC ON", you will hear sound in the auto sound calibration mode.

If you select "ASC OFF", you will hear sound in the mode set in the audio setting of the setup screen.

SETUP

68