Setting
the Speaker Mode
Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.
1 Press MENU button.
In the Speaker
3 Setup, press the ENTER button again.
Press Cursor 
2 button to move to ‘Audio’ and then
press ENTER button.
Press Cursor 
, 
,
, 
buttons to move 4 to the desired
speaker and then press ENTER button.
•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
P. SCAN
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note |
•Depending on PRO LOGIC and STEREO, the speaker mode may vary.
43
