Samsung HT-F4200/EN, HT-F4200/ZF Using the TV Sound Button on Remote Control, Use in this case

Media Play

About characters shown in the display

When the display shows PS,or RT signals,the following characters are used.

•The display window cannot differentiate upper case and lower case letters and always uses upper case letters.

•The display window cannot show accented letters, <A,> for instance, may stands for accented <A’s> like <À, Â, Ä, Á, Å and Ã.>

PTY (Program Type) indication and

PTY-SEARCH function

One of the advantages of the RDS service is that you can locate a particular kind of program from the preset channels by specifying the PTY codes.

To search for a program using the PTY codes

❑Before you start!

•The PTY Search is only applicable to preset stations.

•To stop searching any time during the process, press 5 button while searching.

•There is a time limit in doing the following steps.

If the setting is cancelled before you finish, start from step 1 again.

•When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.

+

RDS DISPLAY		TA
1	2	3
PTY -	PTY SEARCH	PTY +
4	5	6

1.Press the PTY SEARCH button while listening to an FM station.

2.Press the PTY- or PTY+ button until the PTY code you want appears on the display.

•The display gives you the PTY codes described to the right.

3.Press the PTY SEARCH button again, while the PTY code selected in the previous step is still on the display.

•The centre unit searches 15 preset FM stations, stops when it finds the one you have selected, and tunes in that station.

Using the TV Sound Button on the

Remote Control

TV SOUND

TV Sound

You can listen to TV's audio via Home cinema speakers or TV Speaker by TV SOUND button.

1.Connect the HDMI cable to TV and Home cinema. (See page 15)

2.Set the connected Home cinema and TV to Anynet+ (HDMI-CEC) On.

3.Press the TV SOUND button on the remote control.

4.Each time you press the TV SOUND button, TV SOUND ON/OFF flashes shortly on the Display part on the Front panel, then changes to D.IN.

-TV SOUND ON : Output to Home cinema speakers.

-TV SOUND OFF : Output to Anynet+ connected TV Speaker.

❑Use in this case:

1)When you want to listen to the TV's audio via home cinema speakers.

2)When you want to listen to the sound from the USB media that plugged to the TV via home cinema speakers

❑TV SOUND ON/OFF support specification

Connected TV	Anynet+	TV	TV
	(HDMI-CEC)	Sound	Sound
	Setting	ON	OFF
Anynet+	ON	O	O
(HDMI-CEC)
	OFF	O	X
supported TV
Anynet+	No operation	O	X
(HDMI-CEC) not
supported TV

28 English