Setting the Speaker Mode
Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.
Setting the Test Tone | GB |
|
Use the Test Tone feature to check the speaker connections.
In Stop mode,
1 press MENU
button.
In the Speaker
3 Setup, press the ENTER button again.
Press Cursor 2 button to move to ‘Audio’ and then
press ENTER button.
Press Cursor , ,
, buttons to move 4 to the desired
speaker and then press ENTER button.
•For C, SL, and SR, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
1 | In | Stop or no disc | 2 | Press Cursor | 3 | Press Cursor button | |
button to move to | to move to ‘TEST | ||||||
mode, press | |||||||
|
|
| |||||
|
| ‘Audio’ and then |
| TONE’ and then press | |||
| MENU button. |
|
| ||||
|
| press ENTER button. |
| ENTER button. |
• The test tone will be sent to L ➝ C ➝ R ➝ SR ➝ SL ➝ SW in order.
If the ENTER button is pressed again at this time, the test tone will stop.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen. | SETUP |
|
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
• | Test tone will be produced as follows: |
| When playing a DVD or CD, this will work only in Stop |
• | mode. |
Use this function to check that each speaker is correctly |
L: Front Speaker (L) | C: Center Speaker | SW: Subwoofer |
R: Front Speaker (R) | SL: Rear Speaker (L) | SR: Rear Speaker (R) |
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are connected.
Note |
•Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 61).
connected and that there is no problem. |
To end the test tone,
press TEST TONE button again.
Start
51 | 52 |