Samsung HW-F751/UM manual Connecting the Wireless Subwoofer, Connections

CONNECTING THE WIRELESS SUBWOOFER

The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect wirelessly) automatically when the main unit is turned on. If the LINK indicator does not light when the main unit and subwoofer are turned on, please set the ID by following the procedure below.

ENG

1.Plug the power cords of the main unit and subwoofer into an AC wall outlet.

2.Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.

• The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.

3. While the main unit is powered off (STANDBY mode),	POWER	TV POWER
press MUTE on the remote control for 5 seconds.		AUTO
	SOURCE	POWER SPEAKER TV SOURCE

●

CONNECTIONS

4.The ID SET message appears on the main unit’s OLED display.

5.To finalize the link, turn the main unit’s power on while the subwoofer’s LINK LED blinks.

•The main unit and the subwoofer are now linked (connected).

•The LINK indicator (blue LED) on the subwoofer is turned on.

•You can enjoy better sound from the wireless subwoofer by selecting the sound effect. (See page 20)

		SoundShare
REPEAT
TV VOL	TV CH	AUDIO SYNC
TV MUTE TV INFO TV PRE-CH VT DIMMER
SOUND EFFECT	VOL	SMART VOLUME
S/W	MUTE	S/W
LEVEL		LEVEL
SOUND	VOL	DRC
3DPLUS

SOUND EFFECT	VOL	SMART VOLUME
S/W	MUTE	S/W
LEVEL		LEVEL
3D SOUND	VOL	DRC
PLUS

▪Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

▪If the main unit is powered off, the wireless subwoofer will be in the standby mode and the STANDBY LED on the upper side will come on after the LINK indicator (Blue LED) blinks for 30 seconds.

▪If you use a device that uses the same frequency (2.4GHz) near the system, interference may cause some sound interruption.

▪The transmission distance of the wireless signal between the main unit and subwoofer is about 33 ft., but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless signal cannot penetrate metal.

▪If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the connection between the main unit and wireless subwoofer.

▪The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

▪For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

11