Samsung HWF750ZA, HW F750 user manual Auto Sound Calibration

connections

Attaching the Toroidal Ferrite Core to the Power Cord of the Subwoofer

Attaching the Toroidal ferrite core to the power cord of the subwoofer helps prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make two loops around the core with the power cable of the subwoofer.

3.Attach the Toroidal ferrite core to the Subwoofer power cord as the figure

shows and press it until it clicks.

LOOPING THE POWER CABLE AROUND THE TOROIDAL CORE

Lift up to release the	Make two loops around the core	Close the lock.
lock and open the core.	with the power cable. (Start
	winding 5-10cm (12.75 - 25.5
	in.) away from the core).

Auto Sound Calibration

For your best sound experience, ASC provides re-positioning and calibrating Air Track and sound devices including the Sub Woofer, by automatically adjusting sound balance considering the distance between devices and frequency characteristics.

1. Place the ASC Microphone at the listening position.

• You should place the ASC Microphone at the actual listening location first, and then connect the ASC Microphone to the ASC IN jack on the Air Track for precise calibration

2.Connect the ASC Microphone into the ASC IN jack on the Air

track. The Calibration starts automatically and it may take about 2 minutes.

• If you turn off the Air Track or unplug the ASC microphone
before the completion message appears on the display,	ASC
calibration will be cancelled and incomplete. In such a case,	microphone
plug the ASC microphone into the ASC IN jack again.

•When the Calibration completes, you can choose the ASC mode by pressing the Sound Effect button on the remote control.

▪▪ During the ASC calibration, all other buttons do not work except the power button.

▪▪ ASC will abort with error if you change the set’s position in the middle of ASC calibration.

12