ASSEMBliNG THE CLAMP-WIRE
Attach the
CONNECTIONS
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer'slinking ID 1s preset at the factory and the main un1t and subwoofer should link (connect wirelessly) automatically when the ma1n unit and subwoofer are turned on. If the Link indicator ( ~ ) does not light when the main unit and subwoofer are turned on, please set the ID by following the procedure below.
ATTACHING THE TOROIDAL FERRITE CORE TO THE POWER CORD OF THE SUBWOOFER
You can reduce noise caused by electromagnetic radiation by fitting the ferrite core to the power cord of your subwoofer.
p p
/'>-
..._
1.Unlock and open the ferrite core.
2.Wind the power cable of your subwoofer around the ferrite core twice. (Start winding 2 to 4 inches away from the core).
3.Close the ferrite core by pressing it until it clicks.
:·(!),.......~.........
c}
:. m
=
1.Plug the power cords of the main unit and subwoofer into an AC wall outlet.
2.Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.
•The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.
3.While the main unit is powered off (in STANDBY mode), press and hold the ,Z (Mute) on the remote control for 5 seconds.
4.The ID SET message appears on the Soundbar's display.
5.To finalize the link, turn the main unit'spower on while the subwoofer'sBlue LED blinks.
•The main unit and the subwoofer should now be linked (connected).
•The Link indicator (Blue LED) on the subwoofer should be on.
•If the Link mdicator is not solid blue, the linking process has failed. Turn off the main unit and start again from Step 2.
•You can enjoy better sound from the wireless subwoofer by selectmg a Sound Effect.
....; The wireless receiving antenna is built into the
wireless subwoofer. Keep the unit away from water and moisture.
