Samsung LC27A550US/EN, LC23A550US/ZA, LC23A550US/EN, LC27A550USSCI, LC23A550USSCI Using HUB Monitor

2Using "HUB Monitor"

3Right-click on the HUB Monitor’s network device (marked “LAN9512/LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”), and select Use.

Be sure to perform this process before configuring the IP.

4Configure the static IP. Assign the static IP that is allotted to the HUB Monitor’s network device.

Go to Control Panel → Network and Internet → Network and Sharing Center → Change adapter settings. Next, right-click on the HUB Monitor’s network device (marked “LAN9512/ LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”), select Properties → Internet Protocol Version 4 (TCP/IPv4) → Properties, and configure the static IP and DNS settings.

5After configuring the IP, click OK. The following message will appear.

A static IP must be allotted to only one network device. The following message will appear if the same static IP is allotted to the network devices of both the notebook PC and HUB Monitor. (Ensure the network device that is not in use is set to Disable.)

Select No in the message window.

To use the notebook PC’s LAN network, set the HUB Monitor’s network to Disable and the notebook PC’s network device to Use. Next, configure the IP settings.

2 Using "HUB Monitor" 33