There is no image on the screen.
Is the power indicator on the monitor blinking at 1 second intervals?
disappears.
Please change to the recommended mode during this
(The message is displayed again if the system is rebooted.)
The monitor is in PowerSaver mode.
press a key on the keyboard to activate the monitor and restore the image on the screen.
If there is still no image, press the '
' button.
Then press any key on the keyboard again to activate the monitor and restore the image on the screen.
I cannot see the On Screen Display.
The screen shows strange colors or just black and white.
The screen suddenly has become unbalanced.
Have you locked the On Screen Display (OSD) Menu to prevent changes?
Is the screen displaying only one color as if looking at the screen through a cellophane paper?
Have the screen colors become strange after running a program or due to a crash between applications?
Has the video card been set properly?
Have you changed the video card or the driver?
Have you adjusted the resolution or frequency to the monitor?
Unlock the OSD by pressing the [MENU / 
] button for at least 5 seconds.
Check the signal cable connection.Make sure the video card is fully inserted in it's slot.
Reboot the computer.
Set the video card by referring to the video card manual.
Adjust screen image position and size using the OSD.
Adjust the resolution and frequency at the video card.
(Refer to the Preset Timing Modes).
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.
The screen is out of focus or OSD cannot be adjusted.
LED is blinking but no images on the screen.
There are only 16 colors shown on the screen.
The screen colors have changed after
Have you adjusted the resolution or frequency on the monitor?
Is the frequency properly adjusted when checking the Display Timing on the menu?
Have the Windows colors been set properly?
Adjust the resolution and frequency of the video card.
(Refer to the Preset Timing Modes).
Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes.
(The maximum frequency per resolution may differ from product to product.)
Windows ME/2000/XP:
Set the colors properly at the
Control Panel → Display → Settings.changing the video card.
There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found".
Has the video card been | Set the video card by referring to the |
set properly? | video card manual. |
Have you installed the | Install the monitor driver according |
monitor driver? | to the Driver Installation Instructions. |
See the video card manual | Install the monitor driver according |
to see if the Plug & Play | to the Driver Installation Instructions. |
(VESA DDC) function can |
|
be supported. |
|