Samsung LS20AQWJF2/CI, LS20AQWJFVRXSJ, LS20AQWJFV/XSJ, LS22AQWJFV/XSJ manual Attaching a Base

Models: LS22AQWJFV/ILC LS20AQWJFV/XBM LS22AQWJFV/XSJ LS20AQWJFVRXSJ LS20AQWJFV/XSJ LS20AQWJFV/ILC LS20AQWJF2/CI LS20AQWJFV/EDC LS22AQWJFV/EDC

1 65
Download 65 pages 26.61 Kb
Page 15
Image 15

Connections

Monitor and Bottom

Attaching a Base

This monitor accepts a 100 mm x 100 mm VESA-compliant mounting interface pad.

A.Monitor

B.Mounting interface pad (Sold separately)

1.Turn off your monitor and unplug its power cord.

2.Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.

3.Remove the stand.

4.Align the mounting interface pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base.

Do not use screws longer than the standard dimension, as they may damage the inside of the Monitor.

For wall mounts that do not comply with VESA standard screw specifications, the length of the screws may differ depending on their specifications.

Do not use screws that do not comply with the VESA standard screw specifica- tions.

Do not fasten the screws too tightly, as this may damage the product or cause the product to fall, leading to personal injury.

Samsung is not liable for these kinds of accidents.

Samsung is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used or the consumer fails to follow the product installation instructions.

To mount the monitor on a wall, you should purchase the wall mounting kit that allows you to mount the monitor at least 10 cm away from the wall surface.

Contact the nearest Samsung Service Center for more information. Samsung Electronics will not be responsible for damages caused by using a base other than those specified.

Please use Wall Mount according to the International standards.

13

Page 15
Image 15
Samsung LS20AQWJF2/CI, LS20AQWJFVRXSJ, LS20AQWJFV/XSJ, LS22AQWJFV/XSJ, LS20AQWJFV/EDC, LS22AQWJFV/EDC manual Attaching a Base