Samsung MAX-A66R/EDC Where to Install Your Mini-Com- pact System, Connecting the Loudspeakers

Where to Install Your Mini-Com- pact System

ENG

To take full advantage of your new mini-compact system, follow

these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1 Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and pull the cover in the direction of the arrow.

2 Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:

+ on the battery against + in the battery compartment

– on the battery against – in the battery compartment

MAX-A66
	2.1CH SPEAKERS OUT
R	FRONT -H	FRONT -H	L
	R	L
	R	L
	FRONT -L SUBWOOFER FRONT -L
	IMPEDANCE FRONT:4	SUBWOOFER:3
			SW

ENG

AUX2 : Connecting an External Analog Component

Analog signal components such as a VCR.

1 Connect AUX IN 2 (Audio) on the MINI COMPACT rear panel to the Audio Out of the external analog component.

■Be sure to match connector colors.

2 Press the AUX button to select <AUX2> input. The mode switches as follows : AUX 1 ➝ AUX 2.

STANDBY/ON

MP3-CD/CD TUNER AUX USB

VOLUME

Connecting your System to the Power Supply

Before plugging your system into a main socket, you must check

the voltage.

1	Plug the main lead into an appropriate socket.
2	Press the	(STANDBY/ON) button to switch your mini-compact
	system .

		ANTENNA
		FM (75	)
2.0CH SPEAKERS OUT		AUX IN 2
FRONT -H	FRONT -H	L
FRONT -L	FRONT -L	R

3 Replace the cover by sliding it back until it clicks into position.

If you will not be using the remote control for a long time,

remove the batteries to prevent corrosion.

Connecting the Loudspeakers

The loudspeaker connector terminals are located on the rear of the system.

There are four terminals on the system:

left speaker (marked L) FRONT -H (high sound) FRONT -L (low sound)

right speaker (marked R) FRONT -H (high sound) FRONT -L (low sound)

To achieve the correct sound quality,insert those speaker con- nector cables to the speaker connector terminals of the sys- tem.

Make sure the colors of the speaker terminals match the col- ors of the connecting plugs.

MAX-A65
	2.0CH SPEAKERS OUT
R	FRONT -H	FRONT -H	L
	R	L
	R	L
	FRONT -L	FRONT -L
	IMPEDANCE FRONT:4

Connecting Audio from External Components

AUX1 : Front Panel

Audio Cable

(not supplied)

AUX1 : Connecting an External Component/MP3 player

Components such as an MP3 Player

1 Connect AUX IN 1 (Audio) on the MINI COMPACT front panel to the Audio Out of the external component/MP3 player.

2 Press the AUX button to select <AUX1> input.

The mode switches as follows : AUX 1 ➝ AUX 2.

AUX2 : Rear Panel

Audio Cable (not supplied)
If the external analog
component has only
one Audio Out, con-
nect either left or right.		ANTENNA
		FM (75 )
2.0CH SPEAKERS OUT		AUX IN 2
FRONT -H	FRONT -H	L
FRONT -L	FRONT -L	R

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.

Connect a 75Ω antenna to the FM antenna terminal.

Plug the connector on the FM aerial supplied into the coaxial socket (75Ω ) marked FM on the rear of the system.

Follow the instructions given on Page 15 to tune into a radio station, and determine the best position for the aerial.

If reception is poor, you may need to install an outdoor aerial.

To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75Ω coaxial cable (not supplied).

6 7