Demo/Dimmer Function |
| Setting the Clock |
|
|
|
|
|
|
GB
All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".
1 | Press the Demo/Dimmer button. |
| Result: All functions available on the system appear on the front |
| panel display. |
| Each of these are explained in detail in this guide. Please refer to |
| the relevant section. |
2 | Press the Demo/Dimmer button again. |
| Result: The Dimmer function is selected and the display darkens. |
| Press the Demo/Dimmer button once again to brighten the front |
| panel display. |
3 | A display brightness control can only be performed while the |
| system power is on. |
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you purchase the
After a power failure
After unplugging the unit
Remember to reset the time when the clock changes from winter to summer time and vice verse.
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 Switch the system on by pressing Standby/on.
2 Press Timer/Clock twice. Result: CLOCK is displayed.
3 Press Enter.
Result: The hour flashes.
4 |
5 |
6 |
7 |
To... | Press the... |
Increase the hours 
Decrease the hours
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To... | Press the... |
Increase the minutes 
Decrease the minutes
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is in standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
3,5,7 |
4,6 |
2 |
4,6 |
1 |
10
