Rear Panel View, Inserting Remote Control Batteries

Rear Panel View

ANTENNA

AC CORD

2.Headphone Jack Connector

4.AM Aerial Connector Terminal

6.Loudspeakers Connector Terminals

Micro-Component System

To take full advantage of your new micro-component system, fol- low these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

CD	TAPE
	AUX

Before plugging your system into a main socket, you must check the voltage.

1	Check the position of the voltage selector on the bottom of the
	system (OPTION).
2	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
3	Press the On/Standby button to switch your micro-component system on.

Purchase the micro-componentsystem

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery
	compartment cover (rear of the remote control) and push the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:
	+ on the battery against + in the battery compartment
	– on the battery against – in the battery compartment
3	Replace the cover by sliding it back until it clicks into position.

If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.