ENG
All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".
1 | Press the DEMO/DIMMER button. |
| Result: All functions available on the system appear on the front |
| panel display. |
| Each of these are explained in detail in this guide. Please refer to |
| the relevant section. |
2 | Press the DEMO/DIMMER button. |
| Result: The Dimmer function is selected and the display darkens. |
3 | Press the DEMO/DIMMER button once again to brighten the front |
| panel display. |
A display brightness control can only be performed while the system power is on.
1,2,3
Setting the Clock
Your system is equipped with a clock which allows you to turn your system on and off automatically.
You should set the clock: When you first purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing STANDBY/ON. | |
2 | Press TIMER/CLOCK twice. |
|
3 | Result: CLOCK is displayed. |
|
Press PROGRAM/SET. |
| |
| Result: The hour flashes. |
|
4 |
|
|
To... | Press the TUNING button | |
| Increase the hours |
|
| Decrease the hours |
|
5 | When the correct hour is displayed, press PROGRAM/SET. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Press the TUNING button | |
| Increase the minutes |
|
7 | Decrease the minutes |
|
When the correct time is displayed, press PROGRAM/SET. | ||
| Result: The clock starts and is displayed, even when the system is in |
standby mode.
You can display the time, even when you are using another function, by pressing TIMER/CLOCK once.
You can also use, buttons on the main unit to instead of TUNING button or in step 4, 6.
1 In Standby mode, press and hold the POWER button for longer than 3 seconds.
Result: ECO displays and the main set automatically switches itself into the power saving mode.
1
2
3,5,7
4,6
4,6
4,6 | 4,6 |
| |
1 |
|
8