![](/images/new-backgrounds/1273354/27335411x1.webp)
Connecting the Loudspeakers |
| Connecting Your System to the Power Supply |
|
|
|
The loudspeaker connector terminals are located on the rear of both GB the system and the loudspeakers (red and black tabs in both cases).
There are four terminals:
Two for the left speaker (marked L on the system)
Two for the right speaker (marked R on the system) To achieve the correct sound quality, connect the:
Red cable to the + terminal Black cable to the - terminal
1To connect a cable to a terminal, push the tab as far as it will go:
To the left on the system
2Insert the cable up to the plastic sheathing, in the opening.
3Release the tab.
To the left on the system, until it clicks into place
Result: The cable is pinched and held firmly in place.
4Repeat the operation for each end of the cables.
R L
Inserting the Batteries in the Remote Control
You must insert or replace the batteries in the remote control when you:
Purchase the micro component system
Find that the remote control is no longer operating correctly
1Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow.
2Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:
+ on the battery against + on the remote control - on the battery against - on the remote control
3Replace the cover by sliding it back until it clicks into position.
When replacing the batteries, use a new set.
To achieve optimum performance, make sure that the batteries are of the same type.
The power cord lead must be plugged into an appropriate socket.
Before plugging your system into an outlet, you must check the voltage setting (OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of the unit, you may seriously damage your system.
1Check the position of the voltage selector on the bottom of the system (OPTIONAL).
2Plug the power cord (marked AC CORD on the rear of the system) into an appropriate socket.
3Press the On/Standby button to switch your Micro component system on.
(Bottom) |
(Rear) |
6