Samsung MMDB9TH/ESN Connecting to an External Source, Connecting your System to the Power Supply

Where to Install Your

Micro Component System

GB

To take full advantage of your new micro component system, fol- low these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

					Volume
	Color Display	REC/Pause	TUNER/Band	Power	Sound
	/Demo			Surround	Mode
On/Standby			DVD/CD
		CD Synchro		Sleep
	AUX		TAPE		Open/Close
		CD Repeat		Mono/ST
					S.Bass
			Tuning Mode		Level
					Multi Jog
Phones			VD/MP3-CD/CD-R/RW PLAYBACK
MIC	MIC Mixing

Connecting to an External Source

The auxiliary input can be used to take advantage of the sound quality of your micro component system when listening to other sources.

	Examples:	A television
		A video disc player
		A Hi-Fi stereo video cassette recorder
	To connect the external source, the source must have an audio
	output. In addition, you need an RCA connection cable.
1	Set the system to standby mode and disconnect it and the external
	source from the main.
2	Connect the audio cable to the rear of the micro component system.
	Connect the...		To the connector marked...
	Red jack		R (right)
	White jack		L (left)
	For optimum sound quality, do not invert the right and left
	channels.
3	Plug the system back into the main socket and press On/Standby
	( ) to switch it on.
4	Select the AUX source by pressing AUX.
	Result: AUX is displayed.
5	Switch the external source on.
6	Adjust the volume and balance as required:
	Volume	Equalizer	S.Bass

Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo (as if you were in a cinema).

Connecting your System to the Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage.

1	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
2	Press the On/Standby( ) button to switch your micro component
	system on.

8

CD Digital Out Jack

This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment.

(DAT deck, MD recorder, etc.).

Remove the dust cap (1) from the CD DIGITAL OUT jack. Then, connect an optical cable plug to the CD DIGITAL OUT jack.

(1)

When the CD DIGITAL OUT jack is not being used.

Attach the supplied dust cap.