Samsung P1053 Installing the Washing Machine

Installing the Washing Machine

Before using the washing machine, you must remove all of the shipping bolts from the back of the unit. To

remove the bolts:

1. Loosen all bolts with the wrench before removing them.

2. Take each bolt head and pull it through the wide part of

the hole. Repeat for each bolt.

3. Fill the holes with the supplied plastic covers.

4. Keep the shipping bolts for future use.

The water supply hose must be connected to the washing machine at one end and to the water faucet at the

other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move the water

faucet, replace the hose with a longer, high pressure hose.

To connect the water supply hose:

1. Take the L-shaped arm fitting for the cold water supply

hose and connect to the cold water supply intake on the

back of the machine. Tighten by hand.

2. Connect the other end of the cold water supply hose to

your sink's cold water faucet and tighten it by hand.

If necessary, you can reposition the water supply hose at

the washing machine end by loosening the fitting, rotating

the hose, and retightening the fitting.

The end of the drain hose may be positioned in three ways:

The drain hose must be placed at a height of between 60

and 90 cm. To keep the drain hose spout bent, use the sup-

plied plastic hose guide. Secure the guide to the wall with a

hook or to the faucet with a piece of string to prevent the

drain hose from moving.

The drain pipe branch must be above the sink siphon so that

the end of the hose is at least 60 cm above the ground.

Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no

longer than 90 cm.