Fine Tuning Channel Reception

If the reception is clear, you do not have to fine tune the channel, as this is done automatically during the search and store operation.

If the signal is weak or distorted, you may have to fine tune the channel manually.

1Press the MENU button to display the menu.

2Press the ▲ or ▼ button to select Channel, then press the ENTER/OK button.

3Press the ▲ or ▼ button to select Fine Tune, then press the ENTER/OK button.

4To obtain a sharp, and clear picture and good sound quality, press the ◄ or ► button until you reach the optimal setting. Press the ENTER/OK button.

➢ To reset the fine tuning to 0, select Reset by pressing the ▲ or ▼ button. Press the ENTER/OK button.

5Press the EXIT button to exit.

➢Fine Tune Store will change the colour of the Channel OSD (On Screen Display) from White to Red and add the “*” mark.

P1 * Mono

Picture : Dynamic

Sound : Custom

SRS TS XT : Off

−− : −−

Changing the Picture Standard

You can select the type of picture which best corresponds to your viewing requirements.

1Press the MENU button to display the menu.

2 Press the ENTER/OK button to select Picture.

3 Press the ENTER/OK button again to select Mode.

4 Select the required mode by pressing the ▲ or ▼ button, then press the ENTER/OK button.

Available modes: Dynamic, Standard, Movie

➢The settings values may vary depending on the input source. (ex. TV, Component, PC, or HDMI)

➢You can select these options simply by pressing the P.MODE button on the remote control.

➢ Choose Dynamic for viewing the TV during the day or when there is bright light in the room.

Choose Standard for general TV watching mode.

Choose Movie when viewing the movie.

More

Move Enter Return

English - 17