![](/images/new-backgrounds/1155611/155611191x1.webp)
Installation
STEP 5 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.Remove the PE foam sheet on each shelf corner, which is attached to protect the refrigerator during transportation.
2.Plug the power cord into the wall socket to turn the refrigerator on .
3.Open the door, and check if the interior light lights up.
4.Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be slightly chilled, and the motor will run smoothly.
5.Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready for use.
NOTE
When the refrigerator powers on, the alarm will sound. To turn off the alarm, press Freezer or Fridge.
Installation
STEP 6 Temperature Alarm (applicable models only)
•When the freezer compartment is too warm because there has been a power failure, the signal of “-
-When the Freezer or Fridge button is pressed, the “warmest temperature” which has reached in the freezer and fridge compartment is flashed on the display for 5 seconds.
-Then the actual temperature is indicated. To deactivate the Temperature Alarm function, press Door Alarm again.
•This warning may operate;
-When the appliance is turned on.
-The freezer compartment is too warm due to a power failure.
STEP 7 Final check
When installation is complete, confirm that:
•The refrigerator is plugged into an electrical outlet and grounded properly.
•The refrigerator is installed on a flat, level surface with a reasonable clearance from the wall or the cabinet.
•The refrigerator is level and is sitting firmly on the floor.
•The door opens and closes freely, and the interior light turns on automatically when you open the door.