Samsung RF858VALASL/EU manual Operating your samsung refrigerator, Using the Control Panel, Chill

operating your samsung refrigerator

USING THE CONTROL PANEL

Touch and hold this button for

3 seconds to decrease the time needed to freeze products in the Freezer. This can be helpful if you need to quickly freeze easily spoiled

02

1

2

3

9 7

4

5

6

8

items or if the temperature in the freezer has warmed dramatically (For example, if the door was left open).

( 3 ) Alarm (Hold 3 sec for Filter Reset)

This button serves two purposes:

1) To turn the door open alarm on

and off

If the door alarm is set to On, an

alarm beeps if any refrigerator

door is left open for more than two

operating

( 1 ) CoolSelect+ (Cool Select Room)

The CoolSelect button lets you set the Cool Select Room on the bottom right of your refrigerator to one of four settings: Freezer, Soft Freezing, Chill, or Cool.

Press the CoolSelect button for three seconds to activate the Cool Select Room function, and then select one of the four settings.

	Select Freezer to set the Cool Select
Freezer	Room to the same temperature as
	the freezer.
	• Use this setting to keep frozen
	food fresh.
Soft	• Select Soft Freezing to set the
Freezing	temperature in the Cool Select
	Room to -5 °C. This feature helps
	keep meat and fish fresh longer.

Chill	• Select Chill to set the temperature
	of the Cool Select Room to -1 °C.
Cool	• Select Cool to set the temperature
	of the Cool Select Room to 5 °C.
	You can keep water, juice, soft
	drinks, beer, etc. cold.

( 2 ) Freezer (Hold 3 sec for Power Freeze)

Touch this button to set the freezer to your desired temperature.

You can set the temperature between -23 °C and -15 °C.

minutes.

The beeping stops when you close

the door. The door alarm function

is pre-set to On in the factory.

You can turn it off by touching and

then releasing this button.

You can turn it back on in the

same fashion. The icon lights up

when the function is on.

When the Door Alarm function

is on and the alarm sound is

triggered, the Door Alarm Icon will

blink while the alarm sounds.

2) To reset the water filter life indicator.

After you replace the water filter,

touch and hold this button for 3

seconds to reset the water filter

life indicator.

( 4 ) Energy Saver (Hold 3 sec for °C↔°F)

Touching this button turns Energy Saver mode on and off. When you turn Energy Saver on, the Energy Saver icon lights.

Turn Energy Saver off and the icon goes off. The Energy Saver function is set to “ON” in the factory.

If condensation or water drops appear on the doors, turn the Energy Saver mode off.

Touch and hold this button for 3 seconds to switch the temperature units between °C and °F.

operating _23

DA68-02836K (EN)-08.indd 23 2015. 8. 26.

�� 11:37