instALLinG A wAtER LinE Kit
To help promote better health, the water filter removes unwanted particles from your water. However, it does not
sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
For the ice maker to operate properly, a water pressure of 20~125 psi is required.
Within this water pressure range, a 170 cc (5.75 oz.) cup will fill in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to
compensate for the low pressure.
Water line installation kits are available at extra cost from your dealer. We recommend using a water line
installation kit that contains copper tubing and ¼” compression nut.
1. First, shut off the main water supply.

Connecting to the water supply line

Pipe clamp
Cold water line
Shut off valve
2. Locate the nearest cold water drinking line and install the pipe
clamp and shut off valve.
Shut off valve
Pipe clamp
Cold water line Water line installation kit
3. Connect the water line installation kit to shut off valve. Check for leaks, then go to Connecting the Water
Supply Line to the Refirgerator on the next page.
18_ Setting Up
Setting up your French Door Refrigerator