REVERSING THE DOOR SWING

7.Switch the direction of the electric wire as below. Take out the COVER WIRE HINGE L from the underneath the CAP CABI and rejoin it with the electric wire.

8.With 11mm wrench, separate the HINGE SHAFT and then flip the HINGE and reattach the HINGE SHAFT.

9-1. After rejoining the COVER WIRE HINGE L and

the ASSY HINGE UPP, Switch the position of the GROMMET HINGE and the

CAP SPACE DOOR.

SHAFT

GROMMET HINGE

9-2. When disassembling CAP SPACE, do not Push both side hooks but bottom hook as shown.

10.Switch the position of the STOPPER DOOR and the GROMMET HINGE as shown.

-DISASSEMBLY OF THE FREEZER DOOR

11.Remove 2 bolts and screw to disassemble the ASSY HINGE MID.

STOPPER

GROMMET

12.Disassemble the Freezer door by lifting it upward. Be careful not to drop and scratch the Freezer door.

13.Disassemble the COVER LEG FRONT by removing the 2 screws.

COVER LEG

FRONT

14.Disassemble the ASSY HINGE LOW as shown and put the AUTO GUIDE upside down, switch the position of the SHAFT.

AUTO GUIDE

ASSY HINGE

LOW

When joining, tighten

Note a screw not to make unpredicted noise.

16