1.First, shut off the main water supply line.2.Locate the nearest cold, drinking water line.3.Follow the Water line Installation Instructions in the installation kit.
CAUTION

The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.

Close Main

Water pipe

Close Main

No gap

Water pipe

 

4.After connecting the water supply to the water filter, turn your main water supply back on and dispense about 3L to clear and prime the water filter.

Connecting the water line to the refrigerator

1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.

2.Connect both water line from the unit and water line in the kit.

3.Tighten the compression nut onto the compression fitting. There should be no gaps between (A, B & C )

4.Turn water on and check for any leakage.

Remove cap

Loosen a

Water Line

from unit

No gap

Water Line

from unit

08_ setting up
Only connect the water line to a drinkable water source.If you have to repair or disassemble the water line, cut off 6.5mm

of the plastic tubing to make sure you get a snug, leak-free connection.

Before being used, the leakage in these CAUTION places should be examined.•Samsung Warranty does not cover WATER LINE INSTALLATION.

•It will be done at customer’s charge unless the retail price includes installation cost.

•Please contact Plumber or Authorized Installer for the installation if needed.

•If Water leakage occurs due to improper installation, Please contact installer.

SETTING UP THE

REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual. (P8. Selecting the best location for the Refrigerator)

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.

DA68-01817M-EN.indd8

2011.1.11 5:14:16

PM