Removing any residual matter inside the water supply line after installing filter.
1. Turn ON the main water supply & turn OFF the valve to the water supply line.
2. Run water through the dispenser until the water runs clear (approx. 1L). This will clean the water supply system and remove
air from the lines.
3. Additional flushing may be required in some households.
4. Open the refrigerator door and make sure there are no water
leaks coming from the water filter.
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
1.Lift up the icemaker bucket and gently pull out of the freezer.
2.When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap after ice tray is twisted. Check to make sure the amount of water is correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from with in the main water pipes, not the refrigerator.
1 
Feeler Arm 
Ice maker | 2 |
Check the water level
Test button
22_ setting up
