setting up _21
01 sEtting uP
setting up your side-by-side
refrigerator
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water inlet
side of the purifier.
- If water does not come out through the line, check
whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
WATER LINE
PURIFIER
WATER
OUTLET SIDE
OF PURIFIER
Secure the water line.
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the water line is not
excessively bent, pinched or squashed.
CLIP A
WATER LINE
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
INSTRUCTIONS
COMPRESSOR COVER OF
REFRIGERATOR
CONNECTION NUT
Attach the purifier lock-clip.
- Hold the purifier lock-clip in the appropriate position
(under the sink for example) and fix it tightly into place
where to screw.
PURIFIER LOCK-CLIP
Secure the purifier in position.
- Fix the purifier in position, as shown in the figure on the right.
WATER TUBE
PURIFIER LOCK-CLIP
PURIFIER
DA99-02028A(HM09')-EN(0.0).indd 21 2009.6.10 5:8:19 PM