INSTALLATION OF THE WATER DISPENSER LINE
3)Remove the protective cap, then position and insert the filter as shown.
4)Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in posi- tion.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
COVER FILTER
ALIGN THE INDICATION MARK WITH LOCK POSITION.
• Please check that the indication line aligns with the lock position.
NOTE | • If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do |
| |
| not pull down on the cartridge. A small amount of water may drip down. |
| • If your refrigerator does not have a water filter, we recommend installing one if your water |
| supply has sand or particles that could clog the screen of the refrigerator’s water valve. |
| Install it in the water line near the refrigerator. |
Remove any residual matter inside the water supply line after installing filter
1)Turn on the main water supply &
2)Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.
3)Additional flushing may be required in some households.
4)Open the refrigerator door and check if water leaks around the water filter.
ICE | WATER |
• A
NOTE
32